All MetalShaping

All MetalShaping (https://allmetalshaping.com/index.php)
-   Introductions (https://allmetalshaping.com/forumdisplay.php?f=7)
-   -   New to metal shaping (https://allmetalshaping.com/showthread.php?t=17340)

dapalong 11-18-2017 02:55 PM

New to metal shaping
 
Hey Everyone,

I'm Mike from Highland, IL (about 30 miles east of St. Louis, MO). I'm here because I bought a 1969 AMC Javelin last year, and there aren't a lot of replacement panels for those cars. There are tons of things I need to learn how to do, including:
- Make patch panels to replace rusted metal
- Improve dent removal techniques (there are LOTS of dents!)
- Fabricate inner wheel wells
- Install replacement floor pans and quarter panels
- Fabricate trans tunnel (for larger transmission)
- Remove drip rails
- Flush mount windows

I also need to purchase several tools (on a budget), so I'm looking for advice there as well!

Thanks,
Mike

Peter Tommasini 11-19-2017 01:06 AM

Hi Mike welcome to the forum
Peter


All times are GMT -5. The time now is 08:03 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.