Needed informations for a Ford 1934 rear panel
2 Attachment(s)
Hello everyone,
My next metalshaping exercice will be a Ford 1934 rear quarter panel. But because I don't have any original parts available, could someone give me the folowing dimensions : http://allmetalshaping.com/attachmen...1&d=1538328165 http://allmetalshaping.com/attachmen...1&d=1538328165 For the Top bead and the wheel arch bead (because I think they don't have the shame shape), I would like to know A, B, C and R. If the shapes are different, please, tell me. Thank you very much in advance !! |
1 Attachment(s)
As you are in France, I would think your best coarse would be to find someone that could make a paper pattern for you and do some profiles of the "beads". I'm working on a '33 Willys and had the same problem. My answer was to have a quarter moulded (fiberglass) by a person that had a car mould. I would think finding a glass quarter for a Ford would be a lot easier. Then you would have a permanent tool to reference.
Norm Attachment 48920 |
Thank Norson for your answer.
Sorry for the delay of my answer. I don't know people in France having this kind of parts. But I will follow your tip and try to find someone. |
Pat try asking your question here:The H.A.M.B.
Someone at that forum should be able to give you an answer. |
Tried to help but failed
My radius gage for machining is not large enough to measure my '34 panel. I can tell you your dimension "A" is also a radius.
Sorry not being able to help. |
Thank you both for your tips and information.
Yes, I already know the HAMB, I will test it. I am not surprised that A is not flat. Thanks ! |
All times are GMT -5. The time now is 06:21 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.