All MetalShaping

All MetalShaping (https://allmetalshaping.com/index.php)
-   General Discussion (https://allmetalshaping.com/forumdisplay.php?f=15)
-   -   Erco flanger (https://allmetalshaping.com/showthread.php?t=10715)

flakey 01-23-2014 04:13 PM

Erco flanger
 
Hi all.
Does anybody have any photos of the wire edge tooling used in the erco flanger,
Thanks
Fintan

Essexmetal 01-23-2014 09:42 PM

Fintan, I have a couple of sets, I will send you some pictures on the weekend. There are three separate sets of tools and three required set ups. First op is 90 degs. Second takes it to 180 degs. and the third closes the wrap. The neat part is the first 90 degree set creates the inside of material radius for the wire and sets the perfect amount of material length for the wrap. Once that first pass is set you can finish it by hand faster than setting up the other two ops.
Rick

Metalunion 01-23-2014 09:54 PM

Check with cook enterprises. Last I talked to Clay, he had a factory set for sale.

flakey 01-24-2014 05:14 AM

Thanks guys


All times are GMT -5. The time now is 08:28 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.