All MetalShaping

Go Back   All MetalShaping > Search Forums
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: jeffgies
Forum: Basic questions and answers 08-03-2015, 11:41 PM
Replies: 21
Views: 8,127
Posted By jeffgies
Thanks for everyone's input. I think the...

Thanks for everyone's input.

I think the bend in the bed roll that the pic suggests is a bit of an optical illusion arising from the haphazard way I stripped the paint around the patch area....
Forum: Basic questions and answers 08-03-2015, 05:15 PM
Replies: 21
Views: 8,127
Posted By jeffgies
I'm sorry, I was convinced, and still am, that...

I'm sorry, I was convinced, and still am, that there are 2 issues here. I have a hard time seeing how welding off one corner could have an effect along the whole length of an 8' panel. Especially now...
Forum: Basic questions and answers 08-01-2015, 11:57 PM
Replies: 21
Views: 8,127
Posted By jeffgies
what now?

I've managed to return the fold/corner to its original position by stretching the weld. Now most of the patched area is low. Logic tells me that this needs to be shrunk to raise this area up, but...
Forum: Basic questions and answers 07-23-2015, 11:15 PM
Replies: 21
Views: 8,127
Posted By jeffgies
So, I've found the time (courage) to attempt this...

So, I've found the time (courage) to attempt this repair. I've been planishing the 'wing' section and it's coming along, but I'm finding that the lower part of the vertical section still has a...
Forum: Basic questions and answers 10-06-2014, 10:51 PM
Replies: 21
Views: 8,127
Posted By jeffgies
I'll buy that. Unfortunately the upper weld is so...

I'll buy that. Unfortunately the upper weld is so close to the bed roll, I'm going to have a hard time grinding it much less getting a dolly close :(

thanks for the reply

Jeff
Forum: Basic questions and answers 10-06-2014, 08:48 PM
Replies: 21
Views: 8,127
Posted By jeffgies
Thanks John. So you don't think the vertical part...

Thanks John. So you don't think the vertical part of the box side will require shrinking to restore to the proper 'location'?
Forum: Basic questions and answers 10-05-2014, 04:43 PM
Replies: 21
Views: 8,127
Posted By jeffgies
Repairing weld distortion near pick up bed roll

Hi

I need some advice on removing some distortion following welding of a patch panel. I replaced a portion of the 'wing' (top) section of a 51 Ford F1 pickup bed near the bed roll. Despite going...
Showing results 1 to 7 of 7

 
Forum Jump
All times are GMT -5. The time now is 12:39 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.