All MetalShaping

Go Back   All MetalShaping > Search Forums
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

Showing results 1 to 6 of 6
Search took 0.01 seconds.
Search: Posts Made By: foamcar
Forum: Basic questions and answers 08-29-2016, 05:14 PM
Replies: 17
Views: 6,160
Posted By foamcar
Success. I did some heat shrinking at the worst...

Success. I did some heat shrinking at the worst area, then put the shaft collar back on. Got it as tight as I could 2 times, 180 degrees apart. Still a little large and larger yet at the bad spot....
Forum: Basic questions and answers 08-28-2016, 09:03 PM
Replies: 17
Views: 6,160
Posted By foamcar
Lots of interesting suggestions. Thanks all....

Lots of interesting suggestions. Thanks all. Back in the shop after a trip to see my grandsons new place of employment(auto repair shop). Picked up 2 new needle bearings and as suspected, they are...
Forum: Basic questions and answers 08-25-2016, 02:04 PM
Replies: 17
Views: 6,160
Posted By foamcar
Wow! Thanks for all the great advice. I had...

Wow! Thanks for all the great advice. I had ordered 2 new 20mm needle bearings to pick up tomorrow in Saginaw, on my way down to Ann Arbor(MI). They also stock a 2.25" shaft collar, so will pick...
Forum: Basic questions and answers 08-25-2016, 08:34 AM
Replies: 17
Views: 6,160
Posted By foamcar
Joe I have tools to measure. Here is data on...

Joe
I have tools to measure. Here is data on the O.D. of the upper and lower tubes. The diam. variation of the upper is .014" and lower .058". Have not measured since I made it rounder. I will...
Forum: Basic questions and answers 08-24-2016, 11:00 PM
Replies: 17
Views: 6,160
Posted By foamcar
Thanks Jim. Nice low tech that I could do. Good...

Thanks Jim. Nice low tech that I could do. Good point about a strip at a time, and to practice. Now to find some practice tube.

Phil
Forum: Basic questions and answers 08-24-2016, 10:17 PM
Replies: 17
Views: 6,160
Posted By foamcar
How to shrink a tube

The question is basic, but I'm afraid the answer will be advanced way beyond my skill set. But, worth a try. This is a 356 Porsche front axle beam, about 2" O.D. and 1/8"-3/16" wall thickness. ...
Showing results 1 to 6 of 6

 
Forum Jump
All times are GMT -5. The time now is 07:35 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.