All MetalShaping

Go Back   All MetalShaping > Search Forums
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

Showing results 1 to 9 of 9
Search took 0.00 seconds.
Search: Posts Made By: Blackfinger
Forum: Basic questions and answers 06-22-2023, 05:47 AM
Replies: 3
Views: 2,212
Posted By Blackfinger
Ive seen ball bearings of the appropriate ID...

Ive seen ball bearings of the appropriate ID pushed/pulled through the large diameter oil and coolant tube.
Forum: Basic questions and answers 07-12-2022, 05:13 AM
Replies: 60
Views: 15,526
Posted By Blackfinger
Definitely a two man job if heat shrinking.One...

Definitely a two man job if heat shrinking.One man inside with soft dolly to support metal,outside guy heats lump then hits lump down slowly then cools with water.
Forum: Basic questions and answers 07-05-2022, 06:08 AM
Replies: 9
Views: 2,722
Posted By Blackfinger
EWheel?

Thin lover anvil and a band on the top one?
Forum: Basic questions and answers 05-30-2022, 03:47 AM
Replies: 16
Views: 4,701
Posted By Blackfinger
Paper

Paper works on fairly high crown panels.Ones with subtle curvature and shapes need some guesswork.Reading the shape comes from many failures.Once you start forming the panel you can see where it...
Forum: General Discussion 02-14-2022, 04:47 AM
Replies: 29
Views: 7,312
Posted By Blackfinger
Think its opposite to crowning a panel where you...

Think its opposite to crowning a panel where you stretch the middle and shrink the edges.I think Lazze has a video of doing a basic reverse curved panel.
Forum: General Discussion 03-26-2020, 06:19 AM
Replies: 35
Views: 11,770
Posted By Blackfinger
Found a little bit more... ...

Found a little bit more...
http://www.allmetalshaping.com/showthread.php?t=17416
Forum: Welding Sheet Metal 05-03-2019, 02:59 AM
Replies: 34
Views: 20,583
Posted By Blackfinger
Bump

Just to tag this along.Bunnings is using Coregas now.For a Trade n Go D size Argon its $99 exchange.
https://www.bunnings.com.au/coregas-trade-n-go-gas-size-d-argon-gas_p5910384
Forum: Introductions 03-17-2019, 04:41 PM
Replies: 6
Views: 1,843
Posted By Blackfinger
Thanks guys.Im actually rejoining as I was on...

Thanks guys.Im actually rejoining as I was on here many years ago as "Spitty".
Planes Ive worked on were,Spitfire new build,Beaufort and Beaufighter,Hawker Hart plus F111.Also make small parts for...
Forum: Introductions 03-14-2019, 06:12 AM
Replies: 6
Views: 1,843
Posted By Blackfinger
Thank you for letting me join.

Hi my name is Ross and Ive been doing sheetmetal for quite a few years now but needed a step up to get more proficient and have more confidence in what Im doing.
Im primarily an Aircraft Sheetmetal...
Showing results 1 to 9 of 9

 
Forum Jump
All times are GMT -5. The time now is 06:46 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.