Quote:
Originally Posted by HEATNBEAT
I like the way my linear stretcher die works in my Mechammer I decided to make some for the HF planishing hammer. I have sold several on Ebay for $59.99 but I'm offering them here for $40 with free shipping
Attachment 5990
the die is held in with duct tape
I have machined a flat spot on the stem if you decide to drill and tap the
bottom tool holder and insert a set screw to hold in the die
this is 16 gage stretched in a complete circle in about 4 minutes and no marking on the TOP side.
it does leave marks on the bottom side
http://www.youtube.com/watch?v=mT9pJ...e_gdata_player
you can purchase one with paypal:
clscott4@sbcglobal.net
or with a check to:
Rick Scott
1632 Jefferson Ave.
Madera, Ca. 93637
|
Rick, you did a good job on your design. Looks like one from the old Metalshapers website. After years of using duct tape and also trying all sorts of set screws, keepers, flats, indents, pins and keys I just "stick" with the ducktape.