View Single Post
  #510  
Old 07-18-2018, 09:46 AM
Kerry Pinkerton's Avatar
Kerry Pinkerton Kerry Pinkerton is offline
Administrator
 
Join Date: May 2009
Location: Near Huntsville, Alabama. Just south of the Tennessee line off I65
Posts: 8,321
Default

Got it outside for some perspective shots. Also installed the wheel centers. Don't forget there will be a panel below the door to connect the front and rear fender bottoms.

I took some shots at different elevations. Still thinking about the side vents. Will definitely do something different.

Name:  Image00001.jpg
Views: 1932
Size:  63.1 KB


Name:  Image00002.jpg
Views: 1894
Size:  47.9 KB

Name:  Image00003.jpg
Views: 1824
Size:  75.3 KB

And for perspective, here are the glamor shots from the generation 1 back end that I cut off.

Name:  D-014s.jpg
Views: 1759
Size:  61.8 KB


Name:  D-015s.jpg
Views: 1733
Size:  55.1 KB

Back to the current

Name:  Image00010.jpg
Views: 1733
Size:  50.8 KB

Name:  Image00013.jpg
Views: 1777
Size:  72.8 KB

Name:  Imagex00001.jpg
Views: 1803
Size:  47.2 KB

Name:  Image00016.jpg
Views: 1791
Size:  43.3 KB

Name:  Image00022.jpg
Views: 1767
Size:  37.7 KB

Name:  Image00023.jpg
Views: 1736
Size:  47.2 KB

Name:  Image00024.jpg
Views: 1702
Size:  44.1 KB

Name:  Image00025.jpg
Views: 1775
Size:  45.1 KB

Name:  Image00026.jpg
Views: 1737
Size:  39.7 KB

Name:  Image00027.jpg
Views: 1770
Size:  32.3 KB

Once I finish up organizing in the lift room, I'll get back on the decklid. I'm going to, once again, attempt to keep the shop de-cluttered so I can back it out from time to time.

She runs but not well. I think I need to spend more time on tuning it. I also want to redo the clutch slave cylinder. With the original headers, there was not room for a traditional push slave so I went with a pull cylinder. It never was as smooth as I wanted it to be. Now that I have cast iron split headers, I have room to go back to a standard push cylinder. I think the problem is the cylinder itself but as long as I'm changing it, I'd rather go back to a more standard setup.
__________________
Kerry Pinkerton
Reply With Quote