I like the way my linear stretcher die works in my Mechammer I decided to make some for the HF planishing hammer. I have sold several on Ebay for $59.99 but I'm offering them here for $40 with free shipping
stretcher%20hf%20ebay1.jpg
the die is held in with duct tape
I have machined a flat spot on the stem if you decide to drill and tap the
bottom tool holder and insert a set screw to hold in the die
stretcher%20hf%20ebay4.jpg
stretcher%20hf%20ebay5.jpg
stretcher%20hf%20ebay3.jpg
this is 16 gage stretched in a complete circle in about 4 minutes and no marking on the TOP side.
it does leave marks on the bottom side
http://www.youtube.com/watch?v=mT9pJ...e_gdata_player
you can purchase one with paypal:
clscott4@sbcglobal.net
or with a check to:
Rick Scott
1632 Jefferson Ave.
Madera, Ca. 93637