Front fender holder.
The front fender holder was made of 2.5mm sheet metal. I thought I'd make it in one piece.
But I made a simpler solution. Same material from multiple pieces. I'm sending the process. It was quite time consuming.
Many templates, lots of measurements. Many sequential disassembly and assembly.
DSC00827.jpg
DSC00833.jpg
DSC00831.jpg
DSC00838.jpg
DSC00840.jpg
DSC00843.jpg
DSC00889.jpg
DSC00879.jpg
DSC00873.jpg
DSC00864.jpg
DSC00851.jpg
DSC00845.jpg
DSC00844.jpg
__________________
Jaroslav
Last edited by Jaroslav; 07-15-2019 at 05:46 AM.
|