View Single Post
  #17  
Old 10-02-2015, 01:24 PM
metalman sweden metalman sweden is offline
MetalShaper of the Month May 2012, Jan 2013, Oct 2013
 
Join Date: Jan 2012
Location: Sweden
Posts: 1,049
Default

I more or less just have experience from full radius anvils and can just put in my thoughts from there.

The fullradius anvils not call for a stiff frame at all as long as the upper and lower stay lined up center to center.
The pressure I use is very low and basicly I just set it in the morning and not change it at all during the wheeling.

I have found it much more easy to teach people with fullradius becouse it is easy to transfer the " hammer action idea " to the wheeling, most hammers have a true radius and the action is in the teory the same.

The only backside I have seen with flats is not the flats it is poor frames who make it almost impossible to whheling without very sharp lines from the transit between flat and radius when the frame opens up under pressure.
__________________
Per
www.metalmansweden.com

https://www.facebook.com/metalman.sweden
Reply With Quote