wire used for wire edging panels
Hi Guys
I did some searching and can't seem to find any thing!
I hope we can put together a thread that can be used as a resource for the members, and for me to get a couple fenders completed.
If there are any threads already on our site we could link them here.
If members would post up what information they have on wire edging, i would be happy to edit and organize it into a sticky.
thanks in advance for the help.
now for my questions. I am making Rear fenders for a custom Divco milk truck, out of 19 ga. steel (draw quality), and the customer want the bottom edge and around the wheel opening wired to sorta match the front fenders.
years ago I repaired some fenders and the wire was very stiff. like a spring steel. seems that would be very hard to work with, but would add a lot of strength.
So what do you think!
1. What diameter wire should I use?
2. What grade steel should the wire be?
3. Where can I source the wire in 7 - 8 ft lengths?
thanks
Steve
__________________
Steve Hamilton
Hamilton Classics
Auto Restoration & Metalshaping
|