View Single Post
  #7  
Old 12-04-2017, 12:02 AM
neilb's Avatar
neilb neilb is offline
MetalShaper of the Month March 2019
 
Join Date: Aug 2013
Location: Melbourne OZ
Posts: 672
Default

Quote:
Originally Posted by Superleggera View Post
Questions: Which media did you use -- PLA, ABS or other? Did you utilize 100% infill? Layer height
I used PLA believe it or not it's quite minimal at 15% infill, 1mm outer shell.

I did do one before at 20% with a 2mm outer shell but it came unstuck from the bed. If it fails it fails, as long as it does its job it's all good.


Not sure about bead roller dies, I have drawn up some tank roll dies so ill give it a go and report back
__________________
Neil
Reply With Quote