Thread
:
Scratch build Art Deco Roadster
View Single Post
#
510
07-18-2018, 09:46 AM
Kerry Pinkerton
Administrator
Join Date: May 2009
Location: Near Huntsville, Alabama. Just south of the Tennessee line off I65
Posts: 8,321
Got it outside for some perspective shots. Also installed the wheel centers. Don't forget there will be a panel below the door to connect the front and rear fender bottoms.
I took some shots at different elevations. Still thinking about the side vents. Will definitely do something different.
And for perspective, here are the glamor shots from the generation 1 back end that I cut off.
Back to the current
Once I finish up organizing in the lift room, I'll get back on the decklid. I'm going to, once again, attempt to keep the shop de-cluttered so I can back it out from time to time.
She runs but not well. I think I need to spend more time on tuning it. I also want to redo the clutch slave cylinder. With the original headers, there was not room for a traditional push slave so I went with a pull cylinder. It never was as smooth as I wanted it to be. Now that I have cast iron split headers, I have room to go back to a standard push cylinder. I think the problem is the cylinder itself but as long as I'm changing it, I'd rather go back to a more standard setup.
__________________
Kerry Pinkerton
Kerry Pinkerton
View Public Profile
Send a private message to Kerry Pinkerton
Find all posts by Kerry Pinkerton