View Single Post
  #4  
Old 11-20-2017, 10:01 AM
route56wingnut route56wingnut is offline
Administrator
 
Join Date: Jun 2009
Location: dennison Mn.
Posts: 1,022
Default

I have mostly eliminated stuck fasteners with I bit that is used on an air chisel it has either a 3/8 drive or 1/2" drive so as to use Phillips or straight bit sockets with. It also has a feature that allows a 3/4" wrench to go on. This allows the user to put slight pressure with the wrench in the direction for removal while the hammer action is not only vibrating the rust loose but also driving the driver deep into the slot or Phillips recess so that it won't slip out.
__________________
Dan Pate
Reply With Quote