Thread: solidworks help
View Single Post
  #7  
Old 06-16-2015, 06:49 PM
cwilliamrose cwilliamrose is offline
Member
 
Join Date: Dec 2009
Location: SW Florida
Posts: 220
Default

You might try making this formed part as a sheet metal part. That will allow you to bend or unbend the part. You could then try applying the logo on the flattened part which may or may not re-bend when you're done. SWx can be fussy about what happens in the bend areas. If you haven't done any sheet metal parts now is a good time to learn the basics.
__________________
.................Bill
Reply With Quote