[QUOTE=Richard K;98535]
Quote:
Originally Posted by Peter Tommasini
I looked at the video again and at around 6 minutes the guy is pushing the panel forward and in causing the long edges to buckle. At 7 min when they lay the panel on the floor you can see all sorts of rough wheel tracks were the wheeling ended about 4 to 5 inches from the ends of the panel.
As far as how to do wheeling; this video is real confusing. The more I look at it the more I wonder what is going on. The guy at the back obviously is brand new.
At one point mark says "we had to get heavy pressure to get it where we wanted it". Isn't a Cobra hood panel aluminum?
I think IMO the video is simply misleading. A how to video with a new person is probably not a good idea.
|
The results speak for themselves Richard. The panel fit perfectly, was glossy smooth, and was finished in less than an hour with a student. Few metal shapers can achieve that.
One thing I've learned from visiting many high-end shapers is that they all take different roads, but wind up at the same place...perfect panels.
Mark's video may have confused you, but Mark's student learned from it, and in fact has taken several more classes at the AAMS.