Gday metal shapers im after some help. Im attempting my first body work job on my 69 Dodge coronet. The front left fender has copped a good hit at some point in its life and was covered quite deeply in bog. Ive attached a picture(hopefully). It had a deep crease in it which i have managed to get most of it out but now there is still a low spot across the panel which im having dramas getting out. It appears to me that from above the body line(red line) has a low up to the blue line. im just trying to figure out what is the best way to go about fixing this.
20180807_162357.jpg
Thanks