View Single Post
  #1  
Old 12-03-2017, 06:17 PM
Mr fixit Mr fixit is offline
Member
 
Join Date: Aug 2014
Location: Portland, Oregon
Posts: 226
Default Wire edge straightening question

Hi Group,

I have door sill trim pieces that are U shaped with a 2"side x 1" top x 1.5" side x 34" Long and has a wire edge on the 1.5" side. I am straightening the original pieces as they were pried off by a previous owner which bent both sides.

I have got the 2" side done but I seem to be chasing the wire side and can't seem to keep it straight. I have been using a .75" of flat steel as my dolly, should I be using something else for better results?

advise would be appreciated.

TX
Reply With Quote