View Single Post
  #16  
Old 06-22-2018, 12:03 PM
ScooterCO ScooterCO is offline
Member
 
Join Date: Mar 2013
Location: Parker, CO
Posts: 50
Default

Trying to get these photos to show with clicking on them..

I was presented with a sheet of 5052 in the .080. A bit stiff but we will get it done.

First we made the basic pan with a depth if 1.5 inches. I was very careful setting the box break as to not get too tight on the bend and we also drilled the corners before bending.

corner relief.jpg
__________________
Scott

Last edited by Steve Hamilton; 06-26-2018 at 04:40 PM.
Reply With Quote