View Single Post
  #35  
Old 04-03-2019, 03:30 PM
Peter Tommasini Peter Tommasini is offline
MetalShaper of the Month May 2013, Dec 2013
 
Join Date: Apr 2011
Location: Melbourne,Victoria, Australia
Posts: 7,750
Default

Quote:
Originally Posted by RB86 View Post
Thanks Peter . I started one this method last night and plan to try and finish it after work tonight.

Attachment 52153
That's it!.....................
A little at the time till the sides are all the way up and try to bend the sides on a piece of pipe with the right radius ,then blend the shape in on the wheel with light pressure by wheeling side ways (NOT length ways) by pulling down lightly using the proper anvil (not too high crown) that will keep the sides flat rather then full like the first attempt
Peter
__________________
P.Tommasini

Metalshaping tools and dvds
www.handbuilt.net.au

Metalshaping clip on youtube
http://www.youtube.com/watch?v=WEAh91hodPg

Making Monaro Quarter panel:
http://www.youtube.com/watch?v=KIpOhz0uGRM

Last edited by Peter Tommasini; 04-03-2019 at 03:37 PM.
Reply With Quote