Looking good, I’m going to find this process interesting because if it’s technical and precise nature.
I’m curious to hear or see your method of measuring and aligning the suspension at this point?
I start with the project on a “zeroed out” level surface and use my digital angle finder along with staight edges either on the face of the hub, front or back of the spindles etc. to check the appropriate caster or camber. I feel this is close enough for the building process to get “in spec”, later on obviously I’ll have a proper alignment done.
Is this similar to what you would do?
Thanks
__________________
Rush too much trying to get to the end when the end is closer when you take your time.
Dane
|