Quote:
Originally Posted by gashammer
I did the whole weld in one pass...once. Kent is right on the money with his advice. The only thing I can add is to keep your hammer blows light. That panel will want to swell up like a balloon if you use shaping blows instead of planishing blows. A compound curved surface can swell up a bit without being noticed but not that near-dead-flat panel. Also, I've found that my slapping file is a terrific tool to gently raise low spots when doing these long-sided.
Good luck from a fellow Busman!
|
Was that with tig or gas
Very nice van
__________________
Grahame
|