View Single Post
  #23  
Old 01-13-2018, 09:23 PM
MP&C's Avatar
MP&C MP&C is offline
MetalShaper of the month Feb.-11, July - 2018, Sept. 2020
 
Join Date: Mar 2010
Location: Leonardtown, MD
Posts: 1,706
Default

Thanks for the comments!


We were originally going to hinge the console lid along the passenger side, but thought it would be better accessible from either front seat if it was hinged at the rear. We're using the same hinge as we used for the widened glove box door. In our attempt to add a torsion spring to keep the lid upright in the open position, we couldn't find the size to fit our 1/8" diameter hinge pin with enough torsion to hold the lid open. (Yes, even McMaster failed us) So we decided to wrap our own. Here's a fixture we made for the Aloris tool holder on the South Bend to act as a guide for the 1/16" music wire.



We also installed the older 3 jaw chuck, but not before adding a "wire catch"



Here's a video of us wrapping the spring... As my South Bend lacks slow enough speed for such a task, we opted for manual rotation..


https://www.youtube.com/watch?v=OvJAIk1-Cs4


Here's the positioning and function of the hinge with torsion spring installed...


https://www.youtube.com/watch?v=QPPY2dVOzmQ


With our hinge now positioned, we also found we needed to move the hinge closer to the rear edge for better lid clearance while open. Back up and punt you say?

__________________
Robert

Instagram @ mccartney_paint_and_custom

McCartney Paint and Custom YouTube channel
Reply With Quote