Try plasmaspyder.com for a plasma table forum. A lot of good things there.
I bought a Plasmacam 4x4 table in 2005 and a few years later bought a 5x10 Sampson table a few years later. A lot of the people that make the cheap tables don't last but a year or two and you have no support or parts. Plasma tables make lots of smoke and dust and probably shouldn't be around a paint booth. I shovel up 55 gal barrels full of metal dust under my table. I cut 22ga stainless at 300 inches a minute and can quickly turn new metal into scrap. The first day I ran my machine, I ruined three 4x8 sheets of 1/8. My neighbor says "It cost a lot to be stupid". These machines are probably easer to run now than when I started. Just trying to point out some of the bad things. I hope this helps.
Eddie Lawson
__________________
Eddie
|