P1040406 copy.jpg
When making difficult off-set bends in the brake, sometimes the 20ga steel needs more help going into place...
P1040409 copy.jpg
The slapper spreads out the force so the dead-blow hammer makes the sheet move with few marks.
P1040415 copy.jpg
When clamping the part down to make another offset, the slapper again spreads out the clamping force, avoiding marks.
P1040424 copy.jpg
Still a ways to go, but a pretty good start on a rocker panel that bows out and curves under at the same time, with added "artwork" coming along next.