View Single Post
  #103  
Old 09-29-2009, 08:01 AM
Kerry Pinkerton's Avatar
Kerry Pinkerton Kerry Pinkerton is offline
Administrator
 
Join Date: May 2009
Location: Near Huntsville, Alabama. Just south of the Tennessee line off I65
Posts: 8,321
Default

A little. Got the back corner in place:

Name:  LeftR8.jpg
Views: 4706
Size:  25.8 KB

Welded it in, knocked the proud off the welds, and laid the center section in place.

Name:  LeftR9.jpg
Views: 4546
Size:  26.6 KB

Still a LOT of work to do on this fender...on all of them actually. The center section fits pretty well but putting it in place will be non-trivial because of the tipped trunk opening flange.

The two rear fenders will NOT be welded together but rather have a seam in the center. My idea is that the seam will bolt into a piece of aluminum INSIDE the trunk and there will be a piece of trim that covers the seam.

Also, my current thinking is that there will be a recessed license plate area in the center bottom. The exhaust will exit in the center also. Two pipes side-by-side.
__________________
Kerry Pinkerton
Reply With Quote