View Single Post
  #13  
Old 07-19-2018, 10:01 AM
orwell84 orwell84 is offline
Member
 
Join Date: Oct 2017
Location: Northern NY
Posts: 31
Default

At this point I am getting some flexing/oil canning in the area of the red circle when I push on the X. The circles are shallow low spots, the large one in the front being deeper. I am thinking I need to raise the low areas through stretching. I am just not sure how I can do it without the oil canning returning to the large low. Somehow I need to do it evenly or even out the thickness of the metal in that are.. The line is where the brace is.

Any ideas are helpful. Not really worried about making it worse

door panel.jpg
__________________
James

Last edited by Steve Hamilton; 07-19-2018 at 12:23 PM.
Reply With Quote