View Single Post
  #9  
Old 02-07-2016, 02:20 AM
John Buchtenkirch John Buchtenkirch is offline
MetalShaper of the Month October 2012
 
Join Date: Jul 2009
Location: Glen Cove, Long Island
Posts: 1,675
Default

Mike, nice professionally done video. I do the paper patterns with the magnets and fingers cut just like you do but never would use a radius gauge. Once I have the paper fingers lying flat on the panel I dust coat them with fast drying black Krylon. Yes, all my magnets do have many coats of Krylon on them. When I lay my paper pattern on the sheet I can tell by the un-painted parts of the fingers how deep to pull the shrinks plus the width of the un-painted paper gives you a pretty good idea of how much to shrink & where. I mark ¾” out from where the un-painted portion of the finger stops because I learned at Scott Knight’s class that thumb nail dies will shrink ¾” out in front of where you stop going into the panel.

I also mark blank cutting lines with pin-striping tape and sometimes even use flexible magnetic guides for pin-stripers but again I just dust coat them with dark Krylon. I only need the accuracy of a scribe line when I’m joining 2 panels together. ~ John Buchtenkirch
__________________
John
Reply With Quote