Quote:
Originally Posted by Gojeep
When part of a build, there is a lot of interest in the rest of the fabrication too, not just panel shaping on this site. We all have to do that part of the build as well and there is a lot to learn from each other and the different way we do things. So if you can spare the time, would be great to see that added to the thread.
|
Ok, I was curious about that. Since this is a metal shaping forum, I wasn't sure if that was the only thing the posts should focus on for the most part.
I've only got a couple more posts / updates in regards to the sheet metal portion of this project that I did. After that, I'll look through the photos and fill in some of the smaller details, then go back and show / explain what I did on the chassis, etc.