|
#1
|
|||
|
|||
New guy here from SW Wisconsin
Hey all,
My name is Steve. I am a 30 year old gear head that loves to spend time in the shop working on my 79 Camaro's and general metal fabrication. I have slowly been building my collection of metal fabrication equipment. Working on starting a small fab shop on the side in the limited free time I have. I enjoy buying old equipment, tearing them down, and rebuilding them...then of course, putting them to work! I am currently working on powering my tubing roller. Next up is converting my JD2 model 3 to hydraulic and then powering my bead roller. Look forward to being a part of this site and learning a thing or two!
__________________
Steve Benton Speed & Fab Last edited by galooph; 05-16-2018 at 04:41 PM. |
#2
|
|||
|
|||
Welcome to the forum, Steve
|
#3
|
|||
|
|||
Steve where about in Wisconsin are you ? I'm north of Rochester about 35 minutes
__________________
Dan Pate |
#4
|
|||
|
|||
Welcome to the forum, Steve.
__________________
AC Button II http://CarolinaSculptureStudio.com https://www.youtube.com/channel/UCzSYaYdis55gE-vqifzjA6A Carolina Sculpture Studio Channel |
#5
|
|||
|
|||
Hi Steve welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM |
#6
|
|||
|
|||
I am in the very Southwest corner of the state. ~5 minutes north of the Illinois border and ~15 minutes east of the Iowa border. South of Platteville.
__________________
Steve Benton Speed & Fab |
#7
|
|||
|
|||
I don’t think of that as Southwest I thought you meant south of LaCrosse
__________________
Dan Pate |
#8
|
|||
|
|||
Would this be Benton WI?
__________________
Tim Freeman |
|
|