|
#1
|
|||
|
|||
Making a corner out of one piece
I need to make a corner patch for a floor board patch.
I've tried to get the stretch and shrink with my stump and blocking hammer but I can't quite stretch/shrink deep enough. This corners "walls" are about 2 inches deep, with a flange on top. Should I use a tucking fork or perhaps deepen the horseshoe on my stump? Here's a picture of the area (on right), and the patch I made for the one on left. IMG_20190216_163459020_HDR.jpg IMG_20190216_174411378.jpg
__________________
Rob 1950 Cadillac 1956 Cadillac Looking to build my own car from scratch Last edited by RB86; 02-17-2019 at 12:47 AM. |
#2
|
|||
|
|||
That panel turned out real well Rob.
__________________
Will |
#3
|
|||
|
|||
Thanks Will
What do you think about that hole on the right side? It's basically the corner of a box that's 2" deep. I'm trying to make it out of 1 piece if possible.
__________________
Rob 1950 Cadillac 1956 Cadillac Looking to build my own car from scratch |
#4
|
|||
|
|||
If it was me I would block it out. I would make a paper pattern highlight the various detail on the pattern, then transfer that to metal. Cut your blank oversize by at least 3 or 4 inches all around. Then using a blocking hammer and a sandbag I would block it until I got the rough shape and refine it with various dollies, or bench heads until I got it to the correct shape. If you make some profiles of the original shape with aluminum or mdf you could use them to check your progress.
Do a search for Peter Tommasini's posts here. He is the Master and has gone into a lot of detail with questions similar to yours.
__________________
Chris (trying to be the best me I can be) Last edited by Chris_Hamilton; 02-17-2019 at 03:14 PM. |
#5
|
|||
|
|||
Thanks Chris, I ended up just diving in and hammering to my heart's content and then some.
It won't win any beauty awards but it'll do the trick. Still have welding, grinding and to fill a gap or so (really wasn't an easy piece to make super accurately). Just call me patch Adams IMG_20190217_145537151.jpg IMG_20190217_150442321.jpg IMG_20190217_152531349.jpg IMG_20190217_170821087.jpg IMG_20190217_171404994.jpg
__________________
Rob 1950 Cadillac 1956 Cadillac Looking to build my own car from scratch |
#6
|
|||
|
|||
Lookin' good there Rob. Nice choice in your purchased hammer and good thinking on your 'home made' hammer. Call / come see me (with Clint ?), I have some more hammers I'll give to you. I am enthused that some one so young is showing so much interest along with a great attitude and talent.
__________________
Will |
Thread Tools | Search this Thread |
Display Modes | |
|
|