All MetalShaping

Go Back   All MetalShaping > General Metal Shaping Discussion > Miscellanous products related to metalshaping
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

Thread Tools Search this Thread Display Modes
Old 01-02-2019, 10:23 AM
Vics stuff Vics stuff is offline
Join Date: Dec 2018
Location: Anchorage Alaska
Posts: 4

I have a Miller Matic 250 with a spool gun for aluminum. Just finished a snowmachine tunnel restoration project. The tunnel was .062 thick. I used .025 4043 wire. I found that if you were to tilt the mig gun flatter to the work , you would have less chances of blowing through the material and does cut down the heat concentration .
Victor Knott
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:58 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.