#11
|
||||
|
||||
I sure hope to be!
Money is very tight, but I dearly love going to the Sun-N-Fun. It is especially nice to hang out with great people like Carey and George. It makes for a fun week and I can get thawed out after the Ohio winter! You were from Mansfield?
__________________
Jacob Hunsinger Shrinking using a stump: https://www.youtube.com/watch?v=-HAFndATFo4&t=7s Making a reverse using a stump: https://www.youtube.com/watch?v=7PlF1BoMCQI Circular Truss E-Wheel http://allmetalshaping.com/showthread.php?t=15419 Last edited by Jacob; 03-01-2010 at 07:54 PM. |
#12
|
|||
|
|||
Graduated from Mansfield Senior "77"
anything special to fill out on the app. so I'm sure to work with you guys? |
#13
|
||||
|
||||
Charley: Make sure that your registration is for the workshops. Specifically "Metalshapers Workshop". We register through Monda Thompson who is the worksops registrar. I haven't received a registration form yet. She emails them to former workers. I will forward a copy to you when i receive it. She is sometimes late getting the form out.
|
#14
|
|||
|
|||
So should I do anything online yet or just wait till I get info from you?
|
#15
|
||||
|
||||
I graduated Madison '76!
__________________
Jacob Hunsinger Shrinking using a stump: https://www.youtube.com/watch?v=-HAFndATFo4&t=7s Making a reverse using a stump: https://www.youtube.com/watch?v=7PlF1BoMCQI Circular Truss E-Wheel http://allmetalshaping.com/showthread.php?t=15419 |
#16
|
||||
|
||||
If the registration is not to Monda Thompson,it is probably not for a workshop. We will make sure to get you registered.
|
#17
|
||||
|
||||
did those pins come with a plastic coating?....
__________________
cory mackenzie |
#18
|
|||
|
|||
Yes they do. I paid 2.00 for mine from our local bowling alley. They had 10 or so on the counter and I looked them over and picked the one in the best condition.
__________________
Joe |
#19
|
||||
|
||||
I cut a slot in the side and insert a piece of flat steel into them that sticks out about 2".
By mounting the flat part in a vice I have a nice anvil with lots of interesting curves. |
#20
|
||||
|
||||
did u have to melt the plastic off?
__________________
cory mackenzie |
Thread Tools | Search this Thread |
Display Modes | |
|
|