All MetalShaping

Go Back   All MetalShaping > General Metal Shaping Discussion > Basic questions and answers
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 07-08-2018, 01:05 PM
Mr fixit Mr fixit is offline
Member
 
Join Date: Aug 2014
Location: Portland, Oregon
Posts: 226
Default planishing vs stretching

Hi Group,

A basic question of how do you know when your planishing a sheet of steel vs stretching the metal. I'm assuming that some of both is happening using hand held hammers.
I'm not seeing the smoothing of the metal that I'm after (planishing) and I'm hoping it isn't getting much larger. This is a patch panel piece for a front fender that has a low crown bend to it.
I've also read about planishing welds, is this to smooth them out after grinding, filing, sanding to a OK finish then final smoothing with the hammer and dolly to planish the weld.

So the real question, how best to explain planishing metal for a beginner?

TX
Mr fixit
Chris
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

All times are GMT -5. The time now is 12:35 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.