|
#1
|
|||
|
|||
Contour gauges
As you guys know I am working on the model 29. I am having a personal conflict as to the best way to make the contour gauges without a shrinker or stretcher. Any ideas?
|
#2
|
||||
|
||||
I use 1/4 inch plywood.
__________________
Johnny Arial This forum is dedicated to Metal Shaping. Please stay on topic. |
#3
|
||||
|
||||
Chris, you could stretch one side to the the other side to curve away or tuck shrink but to be honest it's going to take you forever to get it right.
HF has the set of "Rancasters" for $199 every day. http://www.harborfreight.com/cpi/cta...emnumber=95062 They're usually on sale and there is usually a 20% off coupon. Lancasters don't do much good putting shape in a panel but they are perfect for contour guages and flanges.
__________________
Kerry Pinkerton |
#4
|
||||
|
||||
Chris, I agree that you need a set of Lancaster shrinker/stretchers. Harbor Freight has the cheapest and will save a lot of time making contour gauges. You will find a lot of places where they will work fine. The biggest drawback is they mark the metal.
__________________
Joe Hartson There is more than one way to go to town and they are all correct. |
#5
|
|||
|
|||
you can bend them by hammering on one edge.
make a simple tool from two pieces of strap iron. bolts on each end with a washer in between them that is just slightly thicker then the strips you are wanting to bend. Bolts about 4 to 5 inches apart. one plate can be made a little wider so it can be held in a vise. now cut strips up to 3/4" wide and sit them in slot and hit on edge in center between bolts. If you are bending a sharper bend you will have to flatten out the strip some if it starts to get to tight in slot. stripbend.jpg
__________________
The Rod Doctor, Richard Crees Last edited by TheRodDoc; 11-09-2009 at 12:10 AM. |
#6
|
|||
|
|||
or with a little more to it to keep the strip from kinking.
Might even work in a pullmax or ricipicating machine. stripbend2.jpg
__________________
The Rod Doctor, Richard Crees |
#7
|
||||
|
||||
The harbor freight shrinker stretcher are cheap but I still don't own one.So I am still making mine the way the cave man use to.
I get the profile right using poster board and then transfer the poster board cut out to the plywood.
__________________
Johnny Arial This forum is dedicated to Metal Shaping. Please stay on topic. |
#8
|
|||
|
|||
Chris,I see you have an E-Wheel already so find a straight cut gear from a transmition shop or such,that is the same diameter as your lower anvils.Rig it to accept bearings and you have a linear stretching device that works real well on angle type stretching.Of course that doesnt take care of your shrinking problem.I cant imagine doing alot of this work without a basic set of Lancasters though.It would be the recomended tool for this,and alot of other aplications.Good luck Dan
|
#9
|
|||
|
|||
well now that I know HF still had them I'll run grab one next time I'm over there. I am still working on getting my EWheel anvils perfectly centered like I want them. I get them where I want them then I move something and it changes hehe. SO tonight I built new holders out of 3/8" plate and bent them and not welded this time. I may change my lower anvil holder arm but we will see. I could take it up so its much closer to the upper wheel.
|
Thread Tools | Search this Thread |
Display Modes | |
|
|