All MetalShaping

Go Back   All MetalShaping > General Metal Shaping Discussion > Basic questions and answers
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 08-31-2018, 01:00 PM
vroom vroom is offline
Member
 
Join Date: Feb 2015
Location: SW Wisconsin
Posts: 65
Default valley forming

I am making a panel to form 4' long valley. So far I have rolled the bottom of the valley using my e wheel and slick tire set-up. Next I began forming the wings (sides) in my hammer using a linear stretch die. As the panel began to arch down I began to think about the different stretching methods. This is how I understand them:

With regular dies the panel stretches in all directions radially from the impact site.

With linear dies the panel stretches perpendicular to the impact site so less stretching is required to get the valley to arch.

When you are stretching in an e wheel the material stretches parallel to the axle of the wheels (anvils) so it won't do the job for getting a valley to arch.

I think this is correct but I could use some reassurance.
__________________
Tim Freeman
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

All times are GMT -5. The time now is 02:10 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.