#1
|
|||
|
|||
Erco flanger
Hi all.
Does anybody have any photos of the wire edge tooling used in the erco flanger, Thanks Fintan |
#2
|
|||
|
|||
Fintan, I have a couple of sets, I will send you some pictures on the weekend. There are three separate sets of tools and three required set ups. First op is 90 degs. Second takes it to 180 degs. and the third closes the wrap. The neat part is the first 90 degree set creates the inside of material radius for the wire and sets the perfect amount of material length for the wrap. Once that first pass is set you can finish it by hand faster than setting up the other two ops.
Rick
__________________
Rick Mammel |
#3
|
|||
|
|||
Check with cook enterprises. Last I talked to Clay, he had a factory set for sale.
__________________
Field Farrar |
#4
|
|||
|
|||
Thanks guys
|
Thread Tools | Search this Thread |
Display Modes | |
|
|