All MetalShaping

Go Back   All MetalShaping > General Metal Shaping Discussion > General Discussion
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 07-08-2018, 07:21 PM
Dodgefran Dodgefran is offline
Member
 
Join Date: Aug 2011
Location: Cranberry Country Carver, MA
Posts: 10
Default Rusted B Pillar Cutting?

I would like to ask all of you what cut off tool (electric, I don't have access to a big compressor for air tools) can I use to fit in this small area to cut the inside two sides of my B pillar. I plan on rebuilding this by patching on the inside two sides. The rest has strong metal left to weld to. I plan to cut about 4" up. My problem is, 1. I don't have experience, and 2. my 4" cutoff wheel may be too big. I definitely need help, and am open to suggestions. Thanks ahead of time.


dOOR B PILLAR 2 1938.jpg
__________________
Fran
Reply With Quote
  #2  
Old 07-08-2018, 08:34 PM
Kerry Pinkerton's Avatar
Kerry Pinkerton Kerry Pinkerton is offline
Administrator
 
Join Date: May 2009
Location: Near Huntsville, Alabama. Just south of the Tennessee line off I65
Posts: 7,515
Default

Not really sure where you are going to cut but if I couldn't use an air saw, I'd probably go for a Saws-all type thing with a metal blade.


__________________
Kerry Pinkerton
Reply With Quote
  #3  
Old 07-09-2018, 06:53 AM
Oldnek Oldnek is offline
Member
 
Join Date: Mar 2011
Location: Ulladulla, Australia
Posts: 1,314
Default

Recipros are great, the tool I found that is invaluable when I was doing home renovations was the Multi Tool.
I thought I would try it in the workshop for bodywork, with the right blades it works fantastic, specially in confined areas, or where other tools can't be accessed easily.
There also great for removing spot welds, just buy the good quality metal blades.
makita-tm3000cx7-320-watt-multi-tool.jpg
__________________
John
EK Holden V8
Reply With Quote
  #4  
Old 07-09-2018, 11:19 AM
Joe Hartson's Avatar
Joe Hartson Joe Hartson is offline
Administrator
 
Join Date: May 2009
Location: Pass Christian, MS
Posts: 4,931
Default

I don't know what the entire B panel looks like or where you intend to make the cuts. I would suggest that you start making some of the panel that you know will need to be replaces, make them longer than what you think they should be. I have always found that you need to cut more than what you think.

This will also allow you select where you can make an easier cut and have the seam easier to weld.

The selections given for cutting have been good ones. Save some of your worn down 4" discs to use in tight spaces. They don't last very long but will let you get into tighter spaces.
__________________
Joe Hartson

There is more than one way to go to town and they are all correct.
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:14 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.