> Tips on measuring a radius - Page 3 - All MetalShaping <
All MetalShaping

Go Back   All MetalShaping > General Metal Shaping Discussion > Basic questions and answers
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

Thread Tools Search this Thread Display Modes
Old 03-13-2018, 07:18 PM
cliffrod cliffrod is offline
Join Date: Dec 2014
Location: Spartanburg, SC
Posts: 994

As mentioned previously, a straightedge will help determine when a straight part ends and a curve begins. After those points are clarified, you can start any necessary faired curve vs true radius deliberations...

As far as transferring such information accurately between unseen surfaces, in the studio I regularly use a small cross or "X" of tape. The pieces of tape are applied face to face to each other. Stick it to one part. Clearly punch/Mark the point to be transferred in the center of the "X". Then put the other part against it so the sticky surfaces facing up stick to this other part. Carefully separate them, leaving the tape "X" stuck to this other part and the information will be accurately transferred.
AC Button II
https://www.youtube.com/channel/UCzSYaYdis55gE-vqifzjA6A Carolina Sculpture Studio Channel
Reply With Quote
Old 03-13-2018, 11:28 PM
bobadame bobadame is offline
MetalShaper of the Month Feb 2015
Join Date: May 2009
Location: Fort Collins, Colorado
Posts: 1,076
Default chord height measuring device

This is the chord height measuring gizmo that I mentioned yesterday. The first picture shows the indicator being zeroed on a flat surface. Second picture is of the bottom of the unit. Last picture shows a reading of .102" chord height on a small fender. Using a chord height calculator that I found on the interwebb. that value equates to 11.08" radius. The design radius for the fender was 11.25". I over did it a bit with the shrinker.

I also used it to measure the top of an old 2002 BMW. The results were both good and bad. First the good, the indicator makes it possible to locate the exact point at which the surface radius begins to change. It also indicates whether the surface is a constant radius or sort of a French curve. So this device could be used to map the surface by locating the points at which the major constant radius ends and another radius begins. To map a French curve type of surface, a flexible tape like a dress makers tape could be placed on the surface along a line and chord height measurements could be taken every inch or two along that line to develop a spline curve.

The bad, on a large radius such as the top of a sedan with a radius in the neighborhood of 130" for example, a difference of .001 equates to difference of 10 to 12". So it's a bit like looking for an elephant with a microscope. One would need to check over a broad area and average the readings.

20180313_194037 (1024x576).jpg

20180313_194230 (1024x576).jpg

20180313_194121 (1024x576).jpg

Don't believe everything you think.

Last edited by bobadame; 03-13-2018 at 11:34 PM.
Reply With Quote
Old 03-15-2018, 09:17 AM
Sprint Relic Sprint Relic is offline
Join Date: Sep 2013
Location: Mesquite, TX.
Posts: 58

I love math
Skip Wilson
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

All times are GMT -5. The time now is 06:43 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.