#1
|
|||
|
|||
Your preferred method to fix oil canning?
What is everyone's preferred method to fix oil canning? I've used shrinking hammers with decent results, and torch/wet rag method. I have yet to try a shrinking disc on an angle grinder.
__________________
Rob 1950 Cadillac 1956 Cadillac Looking to build my own car from scratch |
#2
|
|||
|
|||
Quote:
Well that can be a few things... too much metal or.. to tight, you need to read it right. The best way I found is to use a oxy torch and heat the metal very little, do rather more SMALL shrink that one larger one ( Administrators have not allowed me to to say this on the forum) but if you like... you can see the way I do shrinking on dvd N 10 Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM |
Thread Tools | Search this Thread |
Display Modes | |
|
|