|
#1
|
|||
|
|||
WTB: P5 Bottom Center Tool Holder
WTB: Pullmax P5 Bottom Center Tool Holder
Thanks! PM me.
__________________
Bob Last edited by AlphaBob; 07-23-2019 at 11:13 PM. |
#2
|
|||
|
|||
P5 tool holder
Have you found one yet? Do you currently have fun offset tool holder? I could probably make you a new one.
Jesse
__________________
Jesse If you can't do more with less you will probably do less with more. Be Creative |
#3
|
|||
|
|||
Thanks Jesse!
I’ve decided to machine an adaptor plate out of 6061-T6 aluminum which I’ve got about halfway completed. Today I machined and hand lapped the additional key (which I made out of 4140 because that’s what I had on hand), and machined the keyway on the front of the adapter plate. I’ve also purchased some large round stock to make a genuine center tool holder when I have a little more time. IMG_6437.jpg
__________________
Bob Last edited by galooph; 08-03-2019 at 02:41 AM. |
#4
|
|||
|
|||
I'm angry about the design of the bracket. Once I made a decision and made a simple solution. It's good for some jobs. So far I have not used the machine much, but the lower bracket and its adjustment would like to do better. You have no idea for a flexible holder adaptation. Distance adjustment as needed ????
http://allmetalshaping.com/showthread.php?t=18988
__________________
Jaroslav Last edited by Jaroslav; 08-03-2019 at 02:19 AM. |
Thread Tools | Search this Thread |
Display Modes | |
|
|