|
|
|
#1
10-06-2015, 01:06 PM
|
|||
|
|||
New member from indiana
Hello. Just joined here today. I have a welding/fabricating shop making mostly agricultural equipment. I have been restoring cars for myself as a hobby for 15 years now. I would like to start doing more custom builds and build on my metal shaping skills. My end goal is to build a copy of a kellison x300gt fiberglass body I have.
Marc 
|
|
#3
10-07-2015, 08:04 PM
|
||||
|
||||
|
Hello Marc and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#4
10-08-2015, 08:05 AM
|
||||
|
||||
|
Welcome Marc. That is a pretty rare body and should look great in aluminum.
__________________
Kerry Pinkerton
|
|
#5
10-08-2015, 10:45 AM
|
|||
|
|||
|
Thanks
Thanks for the welcome messages. I am greatly looking forward to building the kellison. I have never built a complete car body, just small panels. So I imagine I will rely on experts here for insight and suggestions.
__________________
Marc
|
|
#6
10-08-2015, 08:57 PM
|
|||
|
|||
|
Hi Marc welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
