|
|
|
#1
10-25-2015, 08:28 PM
|
|||
|
|||
Hello from Austin
Hi, my name is Kelvin. I joined this forum to learn about metal shaping. I am mostly a complete novice, with no tools other than a hammer. Currently I am learning to weld, later I hope to get some shaping tools.
Kelvin from Austin
__________________
Kelvin 
|
|
#2
10-25-2015, 10:05 PM
|
||||
|
||||
|
Kevin, have you ever been to the Handbuilt Motorcycle Show there in Austin? There are a few folks that show bikes that work sheet metal that go there. It's in April but no dates have been set for this next year. I was down there this last April showing my handbuilt BMW.
__________________
http://pokiespages.com/
|
|
#3
10-25-2015, 11:36 PM
|
|||
|
|||
|
Hi Kelvin welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
10-26-2015, 12:53 PM
|
||||
|
||||
|
Hello Kelvin and welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#5
10-27-2015, 06:54 AM
|
|||
|
|||
|
welcome
Howdy to the forum.
You`ll find a lot of good info and knowledge here.
__________________
Marcus Goetting If it was easy -- they would do it at Walmart  www.mgcustomairframe.com www.facebook.com/mgcustomairframe/
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
