|
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
Who out there can make this canister type air cleaner?
20181212_141140.jpg
20181212_141204.jpg 20181212_141147.jpgThese are approx 6-6.5" in diam. Funnel on top and bottom. They'd need the correct clinch/pinch/roll over type seams. I have the "eyebrows", fitting for the top and the threaded part for the bottom. Any suggestions? Thanks
__________________
Roland Last edited by route56wingnut; 01-06-2019 at 02:53 PM. |
#2
|
|||
|
|||
Quote:
How are eyebrows attached? Photo closeup ? Material and thickness, please?
__________________
Kent http://www.tinmantech.com "All it takes is a little practical experience to blow the he!! out of a perfectly good theory." --- Lloyd Rosenquist, charter member AWS, 1919. |
#3
|
|||
|
|||
The eyebrows are soldered on. When I get home end of this week, I'll measure the tin and post it here..
Thanks for the interest..
__________________
Roland |
#4
|
|||
|
|||
Measured, its 20 or 22 gauge steel
__________________
Roland |
Thread Tools | Search this Thread |
Display Modes | |
|
|