#1
|
|||
|
|||
Dimple Slitter
I just go this new tool. Didn't know I needed it, until I saw it!
It's a Dimple Slitter. A few years ago I made some electronics enclosures for an old Bomber, and had to make these dimples by hand. This is the tool. This is the dimple/slit front side Back side. On the electronic case's, these dimples make the feet/drain holes on the enclosure. One in each corner.
__________________
Jeffery |
#2
|
|||
|
|||
Those dimples are nice. You could probably use them for quick fasterners too? The ones that you turn 25 degrees for relaease of fastening.
__________________
jochem www.niezycles.nl |
#3
|
|||
|
|||
Dimple slitter
The tool was used in a sheet metal fab shop years ago. It put rows of dimples in a strip of sheet metal used to hold turning vanes in air ducts. Neat tool ,wish I had one.
Dennis2
__________________
Dennis |
Thread Tools | Search this Thread |
Display Modes | |
|
|