#1
|
||||
|
||||
AC Condenser bracket
I thought I was done with 16 gauge sheet metal when the hood was completed on the Biederman, but here we go again..
I have a couple radius bends to do on the AC condenser bracket, so a piece of 1/2" 4130 was added to the Magnetic Brake die.. This will help keep things from moving, and it is welded on what is usually the back side, so no interference otherwise... This will be the mounting flange to the radiator.. 1" rod is used to form the radius on the side "covers" A test fit before we cut out the gaping hole for air flow. https://www.youtube.com/watch?v=YbIW1kyuTGI The center hole is cut out and a flange tipped for wrapping a 3/16" rod for wire edge. This should add plenty of strength, if the 16 GA wasn't enough.. Our anvil we made up for stretching the metal in the corners for tipping.. Wire edging complete: .
__________________
Robert Instagram @ mccartney_paint_and_custom McCartney Paint and Custom YouTube channel Last edited by MP&C; 11-20-2018 at 11:32 AM. |
Thread Tools | Search this Thread |
Display Modes | |
|
|