|
|
|
#1
01-15-2016, 02:12 PM
|
|||
|
|||
New from Wisconsin
Greetings,
I have a few old rusty Italian cars (Alfa & Lancia) that I dream of restoring some day. First I need to build a workshop (and house)... Hoping to find some good ideas for the workshop here. Later, I'm sure I'll be looking for advice on the actual metalworking. A couple of years ago I purchased a copy of David Gardner's DVD which is quite inspiring! Cheers,
__________________
Dave 
|
|
#2
01-15-2016, 09:07 PM
|
|||
|
|||
|
Welcome to the forum from just over the border, Dave.
In case you haven't already found it, loads of workshop building stories and discussion over at http://www.garagejournal.com/
__________________
Mark from Illinois
|
|
#3
01-16-2016, 04:25 PM
|
|||
|
|||
|
Thanks! I've been to Garage Journal and there is quite a lot there and a huge variety. I'm hoping to find workshop examples here that are more focused on metal shaping and restoration.
__________________
Dave
|
|
#4
01-16-2016, 05:04 PM
|
|||
|
|||
|
Hi Dave welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
01-18-2016, 05:47 PM
|
||||
|
||||
|
Hello Dave and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
