P9 tooling
 

Good day,

I have recently acquired a pullmax P9. It was set up as a nibbler with a tracing table. I am interested in finding the tracing table a good home and am looking for a centered lower tool holder with a 25mm collet. I also am going to need the collet and nut for the upper to minimally begin the forming operations I purchased it for. Any ideas as to where to look for the holders. Trick tools no longer carries any of the components for the P9. Any help would be appreciated.
Thanks,

Stu

Attachment 52924Hi Stu.
Not certain how your P9 tool post is configured, but on the P-21 model, the tool holder can be inserted with the offset inside or outside the throat. Using this ability, I have fabricated a spacer plate to centre the offset tool holder.
Bearing in mind that original accessories for these machines cost an arm and a leg at best, with this method (if possible in your case) you'll have the best of both worlds!
The attached pic illustrates the principle...

I PM'd you regarding the Pullmax parts you are looking for. I have a few original Pullmax parts for P5 thru P9, including collets w/nuts, lower tool holders, tooling, etc.

Let me know if you have any interest in what I have and we can discuss it further.
Thanks.

Hi Stu welcome to the forum
Peter