Hello from WI
 

Hi folks. Im looking to expand my skill set with sheet metal shaping. Occupation is restoring vintage Ferraris. As a hobby, i restore all the shop equipment i buy.

Regards

-Bryan

Hi Bryan and welcome!:)

Welcome to another Wisconsinite!:)

Hi Bryan welcome to the forum
Peter

Welcome Bryan, good to see you here! I've drooled over much of your equipment restorations, can't wait to see more of the automotive shaping!

Hi Bryan

Welcome to Allmetalshaping. I'm in Fond du Lac what part of the state are you in. So Robert apparently has seen pic of the equipment that you have restored, we really like pictures. When you get a chance post up some for all to see.

Steve

Thanks for the warm welcome fellas. Robert, good to see a familiar face on this site. Steve, I'm just a bit north of you in Appleton. Here are a few photos of my implements of destruction. As you can see, most are for making hard parts, but need for sheet metal repair pannels has me geared in the direction of adding things like a planishing hammer and e-wheel.

The band saw frame pictured will be the start of my e-wheel with the help of some anvils from Hoosier Profiles. I still need the basics like a shot bag and some bossing mallets. Also pictured is the reason behind all the madness. I'm putting together a 1950 Chevy truck.

Attachment 26118

Attachment 26119

Attachment 26120

Attachment 26121

Attachment 26122

Attachment 26123

Attachment 26124

Attachment 26125

Attachment 26126